Bissell MULTIREACH ION XL 1971 Serie Mode D'emploi page 8

Maintenance: Brush Roll
WARNING
Do not operate your MultiReach™ Ion XL with damp or wet filters or without filters in place.
1
5
Clean your brush roll as needed and place back into foot.
Make sure the brush roll cover tab is locked back into
place to prevent breaking or faulty brush roll operation.
Maintenance: Disposal of Batteries
NOTICE
Disconnecting the battery will destroy the appliance and invalidate the warranty.
8
www.BISSELL.com
2
-Unplug the charger.
-Remove hand vac from unit and remove dirt cup from handle.
-Remove (2) Phillips head screws and remove the lens from the hand
vacuum.
-Remove (2) Phillips head screws from the hand vacuum cover.
-Lift off the hand vacuum cover and take out the push rod.
-Remove (5) Phillips head screws from the side of the hand vacuum.
-Remove the entire battery assembly from the cover.
-Cut wires from the PCB and wrap the wire ends with insulation tape.
-Keep Battery Pack together – DO NOT separate individual batteries. For
specific disposal instructions of batteries, please follow local regulations.
-Hand in remainder of product at an official collection point for recycling.
3
BRUSH ROLL RESET:
If the brush stops turning,
turn the unit off and
remove and debris that is
blocking the brush. Wait
15 seconds and turn the
unit back on.
4