Assemble Hood; Stroller Operation; Adjust Backrest Angle; Use Buckle - Jole nitro Mode D'emploi

Assemble Hood

Align the holes of the hood mounts with the posts on the tubes, and then insert to assemble the hood
the hook and loop fasteners to attach the rear hood to backrest.
The completely assembled stroller is shown as
9

Stroller Operation

Adjust Backrest Angle

Recline Backrest
Pull the backrest backwards, while pressing the button in the center of the angle adjuster.
Raise Backrest
Push the backrest forwards, while pulling the webbing at the end of the angle adjuster.
!
Make sure the recline is set properly for use.

Use Buckle

Release Buckle
12
Press the center button to release the buckle.
Lock Buckle
Match the waist belt buckle with the shoulder buckle
A "click" sound means the buckle is locked completely.
!
To avoid serious injury from falling or sliding out, always secure your child with harness.
!
Make sure your child is snugly secured. The space between the child and the shoulder harness is about the
thickness of one hand.
!
Do not cross the shoulder belts. This will cause pressure on child's neck.
Use Shoulder & Waist Harnesses
!
In order to protect your child from falling out, after your child is placed into the seat, check whether the
shoulder and waist harnesses are at proper height and length.
14
- 1 Shoulder harness anchor A
14 - 2 Shoulder harness anchor B
14
- 3 Slide adjuster
For larger child, use shoulder harness anchor A and the highest shoulder slots. For smaller child, use shoulder
harness anchor B and the lowest shoulder slots.
To adjust the position of the shoulder harness anchor, turn the anchor to be level with the side facing forward.
Thread it through the shoulder harness slot from back to front.
16
child's shoulder height.
Use slide adjuster to change the harness length.
Press the button 17 - 2, while pulling the waist harness to proper length.

Adjust Calf Support

The calf support has 2 positions.
Raise Calf Support
To raise the calf support, just push it upwards.
Lower Calf Support
Press the adjustment buttons on both sides of the calf support
18 - 2
11
8
10
11
- 1 - 2
13 13
, and click into the center buckle.
- 3
13
15
Rethread it through the slot that is closest to
17
- 1
17 - 3
- 1, and rotate the calf support downwards.
18

Use Front Swivel Lock

7 , stick
Push up the front swivel locks to maintain the moving direction.
Tip
It is recommended to use swivel locks on uneven surfaces.

Use Brake

To lock wheels, step the brake lever downwards.
To release wheels, just lift the brake lever upwards.
Tip
Always apply brake when stroller is in stopped position.
Tip Clean brake system regularly to ensure fully functional. See care and maintenance section.
Tip To ensure brake is fully on, gently rock the stroller backwards and forwards before releasing the handle.

Use Hood

To open the hood, pull hood toward front.
To fold the hood, pull hood toward back.

Fold Stroller

!
Please fold the hood before folding the stroller.
Lift the folding plate
storage latch will automatically hook onto the storage mount, then the stroller is folded and locked completely .

Use Carry Strap

You can carry the stroller with ease by lifting the carry strap.

Accessories

Accessories may be sold separately or may not be available depending on region.
Use Rain Cover
To assemble the rain cover, place it over the stroller, and then attach the 4 pairs of hook and loop fasteners on the
rain cover. 27
!
When using the rain cover, please always check its ventilation.
!
When not in use, please check that the rain cover has been cleaned and dried before folding.
!
Do not fold the stroller after assembling the rain cover.
!
Do not place your child into the stroller assembled with rain cover during hot weather.
Use Armbar
see images

Care and Maintenance

!
Removable seat pad may be washed in cold water and drip-dried. No bleach.
!
To clean stroller frame, use only household soap and warm water. No bleach or detergent.
!
From time to time, check your stroller for loose screws, worn parts,torn material or stitching. Replace or
repair the parts as needed.
!
Excessive exposure to sun or heat could cause fading or warping of parts.
!
If stroller becomes wet, open hood and allow to dry thoroughly before storing.
!
If wheels squeak, use a light oil (e.g., Silicon Spray, antirust oil, or sewing machine oil). It is important to get
the oil into the axle and wheel assembly.
!
When using your stroller at the beach or areas of high dust/sand, completely clean your stroller after use to
remove sand and salt from brake mechanisms and wheel assemblies.
!
If brake pedal stiff/hard to fully engage, flush any debris from brake system with clean water first before
lubricating.
19
20
- 1
20
21
22 23 - 1
, step the folding pedal downwards , push the stroller forward to fold
25
28 - 31
26
23 - 2
. The
24
12