T'nB HPBLED2 Instructions page 4

EN
WIRELESS SPEAKER
Package Contains
a. Wireless Speaker
b. USB charging cable
c. 3.5mm to 3.5mm audio cable
PLAY/PAUSE
MICRO USB CHARGING PORT
PLEASE READ THESE INSTRUC-
TIONS
USING YOUR WIRELESS SPEA-
KER. PLEASE KEEP THESE INS-
TRUCTIONS FOR FUTURE REFE-
RENCE
Your wireless spealer has an internal
rechargeable battery. Improper use
may result in the Wireless Speaker
becoming hot ,ignite or burst and
cause injury if exposed to conditions
of abuse , Be sure to follow the safety
warnings listed below :
! 1. Do not disassemble , throw away
or damage the Wireless Speaker
2. Stop the Wireless Speaker in a dry
HPBLED2-notice.indd 4
TOP OF SPEAKER
/ -/ +/
M
LED
MODE PREVIOUS SONG
LOWER VOLME
BACK OF SPEAKER
ON/OFF SWITCH AUX
CAREFULLY BEFORE
place, keeping it away from damp
corrosive materials and environments
such as salt air .
3. Keep the Wireless Speaker away
from direct sunlight, fire and high
voltage equipment . Do not store the
Wireless Speaker inside a car during
hot weather .
4. The Wireless Speaker is not a toy,
Please keep it out of the reach of
Children.
5. Please do not discard the Wireless
Speaker. Consult your local waste
NEXT SONG
HIGHER VOLME
collection agency for proper disposal
or recycling methods.
Charging the battery
This device has an internal, rechar-
geable battery
1. Plug the charger cable into Speaker
2. Connect the charger to a USB
power source, the red indicator light
will display during charging .
If charging does not start, disconnect
the charger plug it in again, and retry.
Charging the battery fully may take up
to 4 hours.
3. When the battery is fully charged,
the red indicator light will turn off .
Disconnect the charger from the USB
power source and the Speaker. The
fully charged battery has power for up
to 2-3 hours of talk-time or up to 60
hours of standby time .
31/05/2017 10:31