Publicité
Les langues disponibles
Les langues disponibles
Cleaning
Begin with the nozzle 1-2ft away from
the surface and approach with caution
until it reaches the desired position
for overly close spray may do harm to
surface.
WARNING: Do not connect the
machine to water supplies that
are dirty, rusty, muddy, or corrosive.
(Including window cleaning liquids,
plant foods, or fertilizers etc.)
Add and use detergent
Install the soap nozzle before opera-
tion.
NOTE: If necessary, use a funnel (not
supplied)to prevent accidental over-
flows of detergent outside of the tank.
Using the power cord holder
To wind the power cord, turn the hold-
ers outwards. To unwind the hose, turn
the holders inwards.
MAINTENANCE
Remove plug from the socket before carrying out
any adjustment, servicing or maintenance.
Inspect the product for damaged or worn parts before each
use. Do not operate it if you find damaged or worn parts.
Contact your supplier or the manufacturer for replacement
parts.
TROUBLESHOOTING
Symptom
Machine does not start
when the switch is in"
I"position.
Machine pressure is
not consistent.
The pressure of the
pump is not adequate
No detergent
Lance leaks
Electric Pressure Washer
See Fig. K
See Fig. L1,
L2, L3
See Fig. M1,
M2
Possible causes
Power cord is not plugged in.
Socket is defective.
GFCI is triggered.
Pump is faulty.
Air in line.
Water inlet adapter is clogged or dirty.
Water supply is Insufficient.
Water supply is restricted.
Diameter of garden hose is too small.
Leak or kick in hose .
Wrong nozzle is attached
O-ring needs to be replaced. (See
Fig. B1)
Power cord maintenance
If the electrical cord is damaged, do not attempt to repair
yourself; call the Worx solutions center for further assistance.
Pump maintenance
Inspect the pump frequently whether any leaking occurs
around the pump seal. If leaking occurs, please contact the
solutions center for further assistance.
Nozzle maintenance
Remove the nozzle from the lance, then remove any possible
obstructions using the included declogging needle (See
Fig. O).Then use a garden hose to rinse the nozzle by
backwashing.
WARNING: Any other servicing should be
performed by an authorized service representa-
tive.
STORAGE
1. Disconnect the water source. Turn on the pressure
washer for a few seconds until the remaining water flows
out. Then turn it off quickly.
2. Unplug the power supply and wind power cord on the
tool. (See Fig. M1)
3. Disconnect the high pressure hose and the garden hose
(not supplied) .Then wind high pressure hose. (See Fig.
P1) Insert the Wand and lance separately into the Wand
Holder and lance holder. (See Fig. P2)
4. Store in a frost free area with a temperature above
0°C(32°F).
Solution
Plug in power cord.
Check or replace plug, socket, fuses.
Press reset on GFCI plug.
Contact service center .
Remove the nozzle, turn on the machine for a while and
install the nozzle back.
Remove the adapter, rinse it with water and put is back.
Open water source completely.
Check If the water hose kinks or leaks.
Replace with right garden hose .
Replace hose or untie kinks in hose.
Attach the soap nozzle
Replace O-ring .If the problem is not solved ,contact
service center to buy a new lance.
11
EN
Publicité
