Evenflo journey 100 Instructions page 4

ASSEMBLING YOUR STROLLER
5
H
J
K
I
M
Begin assembly of the rear wheels and axle assembly by discarding all packaging.
H I
Slide one wheel and a steel washer onto the axle
wheel, as shown. Make sure the clevis pin is completely pushed through the hole in the
L
housings are facing the same direction. Note:
M
Install the hub cap on the wheel by lining up the notch
completely until it snaps into place. Repeat on the other side.
R
P
Q
6
T
4
I
K
J
L
J K
. Insert a clevis pin through the end of the axle
axle, and make sure the brake
An extra clevis pin and steel washer are included for your convenience.
N O
with the tallest rib in the wheel hub. Insert the hub cap
Turn the stroller upside down.
P
Install H-frame to stroller frame legs
place with audible clicks.
Hold the rear wheel/axle assembly so the brake levers
toward the handle and console.
Slide the brake housings onto the H-frame until they lock into
place with audible clicks.
Pull upward on the rear wheel/axle assembly to make sure it
is locked securely.
S
Slide the front wheel assembly over the front frame leg
U
until the locking tab locks into place with an audible click.
Repeat for other side.
Note: To remove each swivel wheel, press locking tab
slide the wheel off the leg.
S
U
7
O
N
V
M
W
J
to secure the
8
Q
until they lock into
R
face
C
1
A
T
U
and
2
Insert the canopy support tubes
the stroller
Pull upward on the canopy tubes to make sure they are
locked securely.
B
Bring the parent's console
Gently pull out the side of the console and guide the hole
over the post
console.
X
Y
Pull canopy hoop
Push canopy toward handle to close.
Step on the rear brake levers
the stroller.
To release the brakes, lift up on the brake levers.
B
ASSEMBLING YOUR STROLLER
V
into the canopy hinges on
W
until they lock into place with audible clicks.
V
W
B C
up to the parent's handle .
X
Y
. Repeat on the other side of the parent's
USING YOUR STROLLER
forward to extend canopy.
B
to lock the rear wheels on
5