Napa 815-6253 Instructions De Montage page 4

PARTS BREAKDOWN
Step 8
Inserting Locking Drawer Assembly Into the Cart
Before inserting the drawer into the service cart, make sure
the roller bearing case is extended all the way out to the black
plastic end stop. This will ensure proper alignment during inser-
tion. Hold the roller bearing case in place while inserting the
drawer. If necessary, adjust the drawer rails to allow the drawer
to slide on smoothly.
DO NOT FORCE THE DRAWER ONTO THE SLIDE RAILS
Step 9
Attaching Casters
With the keys provided, lock both the locking top assembly
and the locking drawer assembly. This will prevent the
drawer and top from opening when you turn the cart upside
down to attach the casters. Once the top and drawers are locked,
turn the cart upside down so the legs are facing up and you can
see the plastic inserts where the casters will be inserted. Insert
the stem of the caster into the hole in the plastic insert. Using the
rubber mallet, hammer the casters in place until the stem is no
longer visible. Repeat with the other three casters.
NOTE: Make sure both locking casters are either on the right hand
side or left hand side of the cart. Once all casters are installed,
stand the cart upright. Assembly is complete.
2
4
6
815-6253 Parts Breakdown & Operating Manual
2
5
3
8
9.
9
Replacement Parts
Item Part No. No. Required
2 RSSC7 2
3 RSSCPLW 2
4 RSSCPW 2
5 RSSCPP 
6 RSSCPHK 
Also Available
RS8006HDL Chrome Drawer Handle
RS8006LK Drawer Lock with Keys
RS8006LK2 Matching Locks with Keys for Drawer and Top/pr.
RSRBSLIDEC-2 Clip-On Roller Bearing Slides/pr.
RSDET8PK Detents for Slide/8 pk.
4
MODEL 815-6253
SERVICE CART WITH
LOCKING TOP & DRAWER
Description
Chrome Leg/ea.
Locking Caster/ea.
Non-Locking Caster/ea.
Set of 4 Plastic Inserts
Bolt Kit (Incl. 8 ea. of 0mm
and 4mm bolts , washers, nuts
and 4 screws)
rev. 03/22/06