Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY INSTRUCTIONS
Step 4
Connecting the Sliding Drawer Back
Support to the Locking Top Assembly
Insert a 4mm bolt down through back left hole in the locking
top assembly, through the left hole in the drawer support back
panel, and finally through the hole in the left drawer support side
panel. Hand tighten the bolt. Repeat for the back right side.
The locking top assembly, drawer supports and drawer spacer
should now all be successfully connected.
Step 5
Connecting the Bottom Tray to the Chrome Legs
Pick up entire cart and place on top of the bottom tray. Line
up holes in bottom tray with holes in chrome legs. Choose an
aligned hole, position a washer, and insert 0mm bolt through
the washer and hole. Attach inside with another washer and
nut. Hand tighten. Repeat with all remaining aligned holes.
IMPORTANT:
Step 6
Tighten All Bolts
At this point all bolts should be tightened. Tighten bolts opposite
each other rather than tightening all bolts on one side first.
Step 7
Attaching Handle to Locking Drawer Assembly
Insert the 4 drawer handle screws through
the holes in the back of the drawer and tighten
with screwdriver.
815-6253 Parts Breakdown & Operating Manual
4
Side Panel Left
Bottom Tray
Chrome Legs
5
7
3
Locking
14mm
Top Assy.
Bolt
Side Panel Back
10mm Bolts
rev. 03/22/06
Publicité
