Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY INSTRUCTIONS
Step 1
Assembly Preparation
Clear table top and set locking top assembly on table right side
up. Position the locking top assembly so the right side hangs off
the table enough to expose the square holes so the chrome legs
can go through. Insert one set of chrome legs through the 4 holes
as shown in figure .
Step 2
Connecting the Locking Top
Assembly to the Chrome Legs
On right side of cart, line up holes in top tray with holes in the
top of the chrome legs. Position a washer, and insert a 0mm
bolt through the washer and holes. Attach inside with another
washer and nut. Repeat step 2 with remaining holes on right
side of cart.
REPEAT STEPS 1 AND 2 FOR LEFT SIDE OF CART
Step 3
Connecting the Sliding Drawer Side
Supports to the Locking Top Assembly
Before executing this step refer to figure 3.2 to make sure
you are putting the correct drawer support side panel on the
correct side.
NOTE: The locking drawer assembly will not stay in place if the
drawer support side panels are put on incorrectly.
Insert a 4mm bolt through the left front side of the drawer
support side panel first and then up through drawer spacer into
hole in the locking top assembly. Hand tighten the bolt. Repeat
on right front side. Once the drawer support side panels are
attached to the front of the locking top assembly, continue
to Step 4.
815-6253 Parts Breakdown & Operating Manual
1
Locking
Top Assy.
Chrome
Legs
Table
2
Chrome
Legs
Table
3
Drawer
Spacer
14mm
Bolt
Side Panel Left
2
Locking
Top Assy.
Sliding Drawer
Side Panels
Locking
Top Assy.
rev. 03/22/06
Be sure these
holes are at the
back of the cart
3.2
Publicité
