Petmate Le Bistro Mode D'emploi page 2

Continued...
SET CLOCK:
1) Press the (-) side of the On/O switch DOWN.
2) Set unit right side up with LCD screen facing you.
NOTE: Clock will ash "12:00 A.M. " automatically.
3) Press ENTER button to set current time. First the HOUR will be ashing.
4) Use UP or DOWN arrow buttons to set current HOUR.
5) Press ENTER button again and the MINUTES will start ashing.
6) Use UP or DOWN arrow buttons to set current MINUTES.
7) Press ENTER upon completion.
Note: While setting clock during the "Initial Set-up"; if the programming
is not completed the Programmable Portion Right Food Dispenser waits
for you to nish.
Low
Battery
Time must
be set before
Enter
set-up can
continue
SETTING ANY MEAL, MEAL TIME and MEAL SIZE
TO SET MEAL SELECTION:
1) Press and Hold the ENTER button for 2 seconds. "MEALS" will ash.
2) Use UP or DOWN arrow buttons to select the desired Meal to be
DETAIL E
SCALE 2 : 1
programmed. (Breakfast, Lunch or Dinner will ash as UP and DOWN
arrow buttons are pressed)
3) Press the ENTER button to select the Meal.
a) "Yes" will Flash. Press the ENTER to con rm meal time.
b) If you do not wish to set that meal, press the DOWN arrow to select
"No" and press ENTER.
Note: if "No" is selected, press ENTER and the software takes you back
to"MEALS. " Use UP or DOWN arrow buttons to select the desired Meal
to be programmed
4) Hit ENTER again if no other meal is needed.
5) While setting the Meal or Meal Time if process is not completed and
no button is depressed for 2 minutes, the Programmable Portion
Right Food Dispenser abandons the change and goes back into "Auto-
matic Mode", retaining the previous Meal or Meal Time.
TO SET MEAL TIME:
1) Use UP or DOWN arrow buttons to set Meal HOUR.
2) Press ENTER button again and the MINUTES will start ashing.
3) Use UP or DOWN arrow buttons to set Meal MINUTES.
4) Press Enter button when minutes are set. The Menu will automatically
take you to the "Meal Size" programming.
TO SET MEAL SIZE:
1) Use UP or DOWN arrow buttons to increase or decrease amount
of food to be dispensed.
2) Press ENTER upon completion. NOTE: Each bar equals approxi-
mately 1/4 cup. The maximum meal size you may select is 3 cups on
either the 5lb unit and 10lb unit.
3) Continue setting remaining meal times and sizes until complete.
4) Press ENTER after all meals are set, to complete programming.
Low
Battery
Enter
MEALS SERVED:
"SERVED" will show on screen at all times. This indicates number of
meals served.
Meals served will go up to 99 and then reset at 00.
To re-set the "SERVED" counter; press UP and DOWN Arrow buttons
simultaneously and it will re-set to 00.
DETAIL E
SCALE 2 : 1
MANUAL FEED OPTION
Press and hold UP Arrow button for 3 seconds.
Food will be dispensed according to rst Meal set. Repeat if additional
Low
food is desired.
Battery
Enter
REPLACEMENT OF BATTERIES
•When the "LOW BATTERY" warning light is on OR before leaving
for an extended period of time, replace the batteries.
(See "Install Batteries" section)
• Set clock to current time.
NOTE: Meal Programming is stored and will NOT need to be
reprogrammed after batteries are replaced.
Low
Battery
DETAIL E
SCALE 2 : 1
Low Battery
Warning Light
Enter
CLEANING BOWL
1) Place ngers under bowl and lift Bowl up to remove.
2) Pull Bowl out horizontally removing it from the Base.
2) Hand clean with soft cloth and hand dry.
PET TRAINING TIPS
Press Up or
FOR PETS NEW TO THE AUTOMATIC FEEDER
Down Arrows
to Program Some pets may require a special adjustment period to acclimate to
Meal size
their new automatic feeder. If this is your dog or cat, try:
1) Place the Programmable Portion Right Food Dispenser next to your
pet's existing bowl or feeder. (Do not turn the power on)
2) Place food in the bowl of the Automatic Portion Right Food Dis-
penser (only for a period of time to allow adjustment).
TROUBLESHOOTING
1) If no display is showing, turn on power.
2) If the clock is ashing, the unit has lost its power and current time
setting, reset current time.
NOTE: previous meal programming does not need to be reset.
3) If "MEALS" is ashing, this indicates the unit did not completely de-
liver the full amount of food programmed for the meal.
a. Turn unit o , empty the hopper and remove the hopper
from the base.
b. Check for food jamming in the throat of the base.
c. Dislodge food jam. Works best with .5"or smaller diameter food.
Hold for
Manual
d. Re-assemble unit.
Feed Option
e. Turn unit on and reset current time.
CAUTION
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. READ ALL
INSTRUCTIONS BEFORE OPERATING PRODUCT.
• For indoor use only.
• For dry food use only. Works best with .5"or smaller diameter food.
• NOT recommended for puppies or kittens less than 7 months old or
unable to reach the feeding dish.
• Do NOT use this feeder with puppies, kittens, dogs or cats with any
physical disability.
• Do NOT allow small children to play with, in or around feeder.
• Before leaving for extended time, always replace batteries with
3 new, "D" size batteries.
• Do NOT place any foreign object in the feeder.
• Do NOT operate feeder without hopper and hopper lid securely in place.
Warning: Base unit should not be submerged in water at any time,
this will damage electronic components and void the warranty.
Allow parts to dry completely before adding new food.
NOT DISHWASHER SAFE.
3) Keep food in the pet's current bowl (only for a period of time to allow
adjustment).
4) Once you have observed your pet eating from the Programmable
Portion Right Food Dispenser, remove their old feeding dish.
NOTE: Adjustment time for the pet could be as short as a
day or as long as a few weeks, depending on your pet's personality. You
can also introduce your pet to the Programmable Portion Right Food
Dispenser by placing small treats in the bowl.
4) If the "Low Battery" indicator light is lit:
a. Turn unit o .
b. Refer to "INSTALL BATTERIES" Section
c. Turn the unit back on and set current time.
NOTE: Meal programming remains and does not need to be
reprogrammed.
NOTE: Clock will be set after setting minutes and the unit is now in AU-
TOMATIC MODE. While setting current time, if the programming is not
completed the Programmable Portion Right Food Dispenser waits until
the current time is set and will not go into AUTOMATIC MODE.
Replacement parts are available at: www.petmate.com
• Feeder should be placed on a level surface.
• Do NOT disassemble feeder other than bowl, hopper, hopper lid and
battery cover.
• Check the low battery light frequently to be sure the feeder is
dispensing properly.
• Dispose of all packaging material properly. Some items may be
packed in poly bags; these bags could cause su ocation; keep away
from children and pets.
WARNING
• Do NOT place anything on top of feeder.
• Base unit should NOT be submerged in water at any time, this will
damage electronic components and void the warranty.
• NOT DISHWASHER SAFE.