4. Push the loaded magazine back into the grip (it fits only one way).
5. Replace the battery compartment cover and secure it to the grip by tightening the
Phillips-head screw.
ATTACH PROBE
Newer HHB280s ship with the probe attached to the grip. If your probe and grip are
already attached, skip this section. The probe must be attached to the grip or the
LCD will show a blue screen and the advisory "No Signal".
To attach the probe,
1. Slide the metal collar of the grip's coupling back until it touches the rubber boot
on the grip's housing.
2. Line up the alignment key on the probe connector with the flat on the coupling
(see photo below).
3. Push the two ends together until they mate.
4. Tighten the connection by turning the collar in the opposite direction of the
"REMOVE" arrow on the collar. Double-check the tightness of the connection;
if it is not tight, water may enter the system later and ruin it.
To detach the probe, perform the attachment procedure in reverse. To loosen the
connection between the two components, turn the collar in the direction indicated
by the REMOVE arrow.
ATTACH VIDEO CABLE (OPTIONAL)
If you wish to view video captured by the HHB280's probe on an NTSC-format
television, insert the mini-plug end of the supplied video cable into the VIDEO OUT
jack behind the LCD (Fig. 2, Callout K). Insert the yellow RCA plug at the other end of
the cable into the television's "Video In" jack.
After you make the connection, you can watch live video on both the HHB280 and
the TV at the same time. Note: the image flip and image zoom functions are
disabled for video exiting through the VIDEO OUT jack.
8
Flat on
grip coupling
Rubber boot
Alignment key on
probe connector
Metal collar