Setup Instructions; Install Batteries - Omega HHB280 Manuel De L'utilisateur

A
B
Fig. 2. The controls, indicators and connectors
of the HHB280
A. Thread protector
B. Camera head and LED lights
C. 9mm flexible-obedient probe
D. LCD
E. Battery compartment (on bottom of grip)
F. button. Increases brightness of LED lights
G. button. Inverts video 180°
H. button. Decreases brightness of LED lights
I. button. Enlarges video frame up to 2X. Each press of button increases
zoom level by 10 or 20%, relative to real size
J. button. Powers unit on and off
K. VIDEO OUT jack (behind LCD)

SETUP INSTRUCTIONS

INSTALL BATTERIES

The HHB280's battery compartment is accessible
from the bottom of the grip (Fig. 2, Callout E).
To install batteries,
1. Use a Phillips-head screwdriver to loosen the single
screw securing the battery compartment cover.
Remove the cover and set it aside.
2. Extract the battery magazine from the grip by pulling
on the tab at its end (see top figure).
3. Load four "AA" batteries into the magazine, using
the polarity markings within it as a guide (see bottom
figure).
C D
E
F
G
H
K
I
J
7