Publicité
Les langues disponibles
Les langues disponibles
4.
The desired air humidity level can be selected by pressing the Humidity button (12) on the
Control Panal. The device will be shut off automatically when the room humidity reaches
the given level. On the Display panel (7), it shows the current humidity level in the room. By
desired humidity level or at continuous model, the unit is set and the display will switch to
show the actual room humidity level again. Note: on "continuous" the unit will NOT turn off
automatically.
Caution: the device will not be switched on if the humidity level is set too low.
5.
Pressing the Output button (13) on the control panel, you can change the volume of out-
put mist from Level 1 to Level 3 (shown on the display panel).
6.
"Warm Mist" button (14): a heater can be switched on by pressing this button. This heater
will heat up the water to 80 C° before it enters into the mist generation chamber. By this
pre-heating function, the temperature of the output mist will reach 40 C°, which will not
cause the room temperature to drop when mist evaporates. An orange LED light on the
top of the display panel will be switched on when this pre-heating function is turned on.
Press this button again to switch off this function, and the LED light will be switched off.
7.
"Night Mode" button (15): by pressing this button, the device is switched to Night Mode
with dimmed LED light on the display. You can change these settings by pressing the
"Humidity" button and "Output" button. And the LED lights remain dimmed in this mode.
To cancel this mode, you can press the "Night Mode" button again.
8.
matically. The ventilator adjusts the levels automatically according to the current room
humidity:
Room humidity (%) Speed level of ventilator
By pressing this button again, the "Auto Mode" is deactivated. The humidity and ventilator
speed settings are switched to the previous settings, before "Auto Mode" was activated.
9.
"No water" alarm light: At the lower part of the display panel, there is red LED alarm light.
This light will on when there is no water or not enough water in the mist generating cham-
ber. When this light is on, you should switch off the unit buy press the " On/Off Switch" and
refill the Water Tank with fresh water, put it back onto the unit and switch on the unit again.
Note: turn off the unit before taking off the tank. You need to turn on the unit again when
placing the tank back to the unit.
Althrough the unit shuts off its motor and its transdusor automatically when water runs off
and the "No water" LED light turns on, in order to avoid unexpected damages, we recom-
mend you to switch off the unit by pressing the On/Off Button as soon as the "No water"
Light is on.
IMPORTANT SAFETY GUIDELINES
•
Do not place the device directly on the oor. Moisture might not evaporate and harm wod
den oors or carpet.
•
Please read through the instruction manual carefully before using the Hera humidifier for the
first time, and store it in a safe place for future reference. If you ever give the humidifier to a
new owner, ensure that you also pass on this instruction manual.
•
Swizz Style accepts no liability for any damage that is caused by non-compliance with this
instruction manual.
•
The device is only to be used in the household for the intended purpose described in this in-
3
2
1
-
-
9
Publicité
