MaxLite BayMax BLHE3 Serie Mode D'emploi page 6

Operating Instructions
MaxLite BayMax Linear High Bay Eco Series
®
CEA-RDW Adapter Installation Instructions
General Wiring Diagram
CAUTION: Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply.
Vaux- Vaux+
DIM-
(Gray/Pink)
DIM+ (Purple)
0-10V DIM LED Driver
LED- (Black)
LED+ (Red)
1.
Open the driver compartment of the fixture by removing the screws on the back of the fixture. Knock
2.
away the knockout hole on one of the sides of the fixture.
Run the wires from the adapter through the knock out hole of the fixture and attach the adapter using
3.
the locking nut. Ensure that the adapter is facing downwards after the fixture is installed.
Connect the wires according to the wiring diagram. Close the driver compartment and secure it with
the screws.
© Copyright 2022. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: info@maxlite.com
Fixture
Lock Nut
Purple
Adapter
Gray/Pink
Yellow
L
N
GND
BLHE3 Series
Page: 6
REV: 03/30/22