Publicité
Les langues disponibles
Les langues disponibles
Safety Warnings for Drills
f Hold power tool by insulated gripping sur-
faces, when performing an operation where
the cutting accessory may contact hidden
wiring or its own cord. Cutting accessory
contacting a "live" wire may make exposed
metal parts of the power tool "live" and
could give the operator an electric shock.
f Use appropriate detectors to determine if
utility lines are hidden in the work area or
call the local utility company for assistance.
Contact with electric lines can lead to fire
and electric shock. Damaging a gas line can
lead to explosion. Penetrating a water line
causes property damage or may cause an
electric shock.
f Switch off the power tool immediately
when the tool insert jams. Be prepared for
high reaction torque that can cause kick-
back. The tool insert jams when:
— the power tool is subject to overload or
— it becomes wedged in the workpiece.
f Hold the machine with a firm grip.
action torque can briefly occur while driving
in and loosening screws.
f Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held
more secure than by hand.
f Keep your workplace clean. Blends of mate-
rials are particularly dangerous. Dust from
light alloys can burn or explode.
f Always wait until the machine has come to
a complete stop before placing it down.
tool insert can jam and lead to loss of control
over the power tool.
f Never use the machine with a damaged ca-
ble. Do not touch the damaged cable and
pull the mains plug when the cable is dam-
aged while working. Damaged cables in-
crease the risk of an electric shock.
Functional Description
Read all safety warnings and all in-
structions. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or se-
rious injury.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.
ENGLISH
7
Intended Use
The machine is intended
metal, ceramic and plastic. Machines with elec-
tronic control and right and left rotation are also
suitable for screwdriving.
Product Features
The numbering of the product features refers to
the illustration of the
page.
1 Keyless chuck
2 Front sleeve
3 Rear sleeve
5 Lock-on button for On/Off switch
6 On/Off switch
7 Rotational direction switch
Assembly
Changing the Tool
High re-
f Before any work on the machine itself, pull
the mains plug.
f Wear protective gloves when changing the
tool. The drill chuck can become very hot
during longer work periods.
Keyless Chuck (see figure A)
Hold the rear sleeve 3 of the keyless chuck 1 tight
and turn the front sleeve 2 in rotation direction Œ
until the tool can be inserted. Insert the tool.
The
Hold the rear sleeve 3 of the keyless chuck 1
tight and firmly tighten the front sleeve 2 by
hand in rotation direction , until the locking
action (click) is heard. The drill chuck is locked
automatically.
The locking is released again to remove the tool
when the front sleeve 2 is turned in the opposite
direction.
Screwdriver Tools (see figure B)
When working with screwdriver bits 8, a univer-
sal bit holder 9 should always be used. Use only
screwdriver bits that fit the screw head.
Replacing the Drill Chuck
For machines without spindle lock, the drill
chuck must be replaced through an authorized
after-sales service agent for Stayer power tools.
The drill chuck must be tightened with a
tightening torque of approx. 31–35 Nm.
7
for drilling in wood,
machine on the graphics
Publicité
