Hydrocell GFS-A1 Manuel D'utilisation page 11

Wash pro
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 27
TO CLEAN SPRAY NOZZLE
StEP 1
Pull back quick disconnect
and detach the nozzle from
the hose.
StORING PORtABLE cAR WASHER
This portable car washer should be stored in such a way to protect it from freezing. Do not store
this unit outdoors or on an area where temperatures will fall below 32'F. This can cause extensive
damage to this unit and void the warranty. Before storing, consider the following steps. Follow shut-
ting down instructions.
DRAIN WAtER FORM SYStEM:
1.
Turn off portable cleaner, squeeze nozzle lever to release pressure. Remove nozzle and
squeeze level and drain water from nozzle. Empty water from tank. Turn unit on and run for
approximately 30 seconds without nozzle.
2.
Detach high pressure hose. Elevate one end and allow water to drain from hose.
3.
Place hose, nozzle and power cord in mesh storage compartments.
4.
If unit must be stored under freezing condition, or will be stored for more the 30 days, a pump
winterizer/protector or a non-toxic RV anti-freeze can be used to prevent freezing and reduce
mineral deposits.
ADD ANtI-FREEZE AS FOLLOWS:
1.
Pour approximately 1/2 gallon of RV anti-freeze into tank.
2.
Connect high pressure hose, nozzle, and power cord.
3.
Turn unit on, squeeze lever until a steady stream of RV anti-freeze in present.
4.
Turn unit off. Squeeze nozzle lever to release pressure.
5.
Remove and place hose, nozzle and power cord in mesh storage compartments.
StEP 2
Clean the nozzle with the
tool. Remove any dirt from
the nozzle and rinse.
Wash Pro - Instruction Book
REPLACE FUSE
Unscrew end of power cord
adaptor to remove old fuse.
Discard and replace with new
fuse.
11

Publicité

Table des Matières
loading

Table des Matières