General Maintenance - Hydrocell GFS-A1 Manuel D'utilisation

Wash Pro - Instruction Book
Pull trigger on spray gun and adjust water as needed.
SHuttING DOWEN YOuR PORtABLE cAR WASHER:
1. Place the ON/OFF switch in the OFF position.
2. Pull trigger on spray nozzle to relieve any water pressure in hose or spray nozzle.
3. Disconnect hose from unit.
4. Disconnect nozzle from hose.
5. Press spray nozzle to remove excess water.
WARNING: ALWAYS DISCONNECT THE PLUG FROM THE POWER SUPPLY BEFORE ANY
MAINTENANCE IS STARTED.
1. WAtER FILtER:
2. NOZZLE cLOGGED:
the portable washer to surge. If this happens turn unit off and unplug pressure washer:
• Unplug power supply, pull trigger on spray nozzle handle to relieve pressure, remove
nozzle from hose.
• Clean the spray nozzle with the nozzle cleaning tool.( See Diagrams 1&2 below).
• Flush wand assembly backwards with water or compressed air.
• If pressure is still too high, repeat steps 1-2.
3. LuBRIcAtION:
hose connector o-rings if connecting becomes difficult.
4. Add some silicone grease to the metal part of the spray nozzle after long time no use.
WARNING: HIGH PRESSURE HOSE, DAMAGED HIGH PRESSURE HOSES CAN BURST AND
CAN CAUSE A POTENTIALLY HAZARDOUS SITUATION OR INJURY. HIGH PRESSURE HOSE
S SHOULD NOT BE KINKED, CRUSHED, TWISTED, OR DAMAGED IN ANY WAY. REPLACE
THE HIGH PRESSURE HOSE SHOULD THIS OCCUR.
10

GENERAL MAINtENANcE

Inspect the water filter before filling with water. Clean water filter if dirty.
A clogged nozzle will cause the operating pressure to be too high causing
No lubrication is required for this pump. Silicone grease may be added to