Power Dynamics PD632 Serie Manuel D'instructions page 5

OPERATION

Switch on the receiver with the power switch.

Screw or open the battery cover of microphone and put new or
full charged battery inside. Press the power switch on the
microphone for 2 seconds, to switch on.

Select automatic (Auto search) or manual (IR) search function.
Automatic
Perform the automatic channel scan on each receiver section
to select an interference-free transmission channel.
Press the ▲ or ▼ button, to select Auto Seach and confirm
with the SET button. Select YES and confirm with SET button
again, the auto search will starts, when the scan is complete,
the display shows the number of the channel found.
Manual
Press the ▲ or ▼ button, to select IR and confirm with the
SET button. Select YES and confirm with SET again. Select your transmission channel, with the ▲ and ▼ button on
the receiver. Hold the IR sensor of microphone close to the IR sensor of the receiver. Press shortly on the SET button
of the respective channel to synchronize the microphone.
Noted: how more numbers of bars are displayed, how better is the reception.

Screw or close the battery cover onto the microphone again.
Noted: Press power ON/OFF button on the receiver for twice shortly, to leave menu.
For optimum receiving:

Reposition the receiver so there is nothing obstructing a line of sight to the microphones (including the audience).

Avoid placing microphone and receiver where metal or other dense materials may be present.

Place the receiver on the top of the equipment rack.

Remove nearby sources of wireless interference, such as cell phones, two-way radios, computers, media players, Wi-
Fi devices, and digital signal processors.

Charge or replace the microphone battery.

Keep microphones more than two meters (6 feet) from each other.

Keep the microphones and receiver more than 5 meters (16 feet) apart.

During sound check, mark trouble spots and ask presenters or performers to avoid those area.
HEADSET MICROPHONE
Connect the connecter of supplied headset microphone to the
connecting jack of bodypack.
Position the headset microphone approx. 15 mm (1/2 inch) from
the opening of your mouth.
5