Publicité
Les langues disponibles
Les langues disponibles
7. Click Add.
If an "unable to configure Internet Access", "UPnP Client Error" or similar
message is displayed, refer to the Troubleshooting section.
8. Once the "camera is ready for use" message is displayed, click OK. The
defined IP camera is displayed in the IP Cameras page.
Figure 9 IP Camera List
NOTE – You also have the option to edit
Defining Camera Trigger Settings
Any event from the following list can be defined to trigger an alarm.
Fire Alarm
Full Arm
Tamper
Environ. Alarm
Alarm
Partition Events
Panic Alarm
Part Arm
24 HR-X Alarm
No Motion Alarm
Detector Events
Zone Bypassed
or delete
the selected IP camera.
Medical Alarm
Disarmed
Water Alarm
Exit Alarm
Zone Un-bypassed
10
Alarm
Duress
Gas Alarm
Low Temperature
Zone Tamper
Publicité
