Fancom FB.1 Notice page 6

To save battery power during a power disruption, the audio or visual signal can be set in four ways. Determine the
time for the siren interval with the J4 and J5 jumper settings:
Audio or visual signal time interval
Continuous
1 minute on / 1 minute off
2 minutes on / 6 minutes off
1 minute on / 7 minutes off
You can set a delay time for the audio or visual signal and for the telephone dialler. Whenever a signalling situation
occurs, the audio or visual signal and/or telephone dialler will start working only after the passage of the delay time.
This allows you to prevent unnecessary signalling due to brief interruptions/deviations.
Telephone dialler delay time
Determine the delay time with the J6 and J7 jumper settings:
Telephone dialler delay time
None
2 minutes
4 minutes
6 minutes
Delay for the audio or visual signal
Determine the delay time with the potentiometer P4:
Delay for the audio or visual signal
A minimum of 2 seconds (standard)
Maximum + 60 seconds
Gndfp
J4
No
Yes
No
Yes
J6
No
Yes
No
Yes
P4
Turn completely to the left
Turn completely to the right
J5
No
No
Yes
Yes
J7
No
No
Yes
Yes
g
3