Installation - SmartPool Robo kleen Mode D'emploi

Cleaning Brushes

Installation

The power supply should be positioned so that Robo-Kleen can reach all the
walls of the swimming pool and must be at a minimum distance of 10 feet from
the edge of the pool.
CAUTION: INSURE THE THE 110V MAIN LINE OUTLET IS PROTECTED BY A
GROUND FAULT CIRCUIT INTERRUPTER (GFCI) OR EARTH LEAKAGE CIRCUIT
INTERRUPTER (ELCI). OTHERWISE, DEATH OR INJURY CAN RESULT.
DO NOT ALLOW POWER SUPPLY TO BECOME SUBMERGED IN POOL.
!
DEATH OR INJURY CAN RESULT. DO NOT PLACE ON EDGE OF POOL.
POWER SUPPLY MUST NOT FALL INTO POOL!
To connect Robo-Kleen to the power supply,
remove the cap on the transformer output socket.
Plug the Robo-Kleen cord into the socket. Notice
the plug and socket are indexed using pins.
Tighten the threaded plug cover so that the cord is
securely attached.
4
Underside of Mobile Cleaning Unit
Locking Tabs
Locking Tabs
Suction Ports