Taurus Alpatec SNOWFIELD BABEL Mode D'emploi page 9

- It is essential that the batteries should always
be the same kind and the same charge. Never
mix alkaline batteries with normal one (Car-
bon-Zinc) and/or rechargeable ones.
INSTRUCTIONS FOR USE
BEFORE USE:
- Make sure that all products' packaging has
been removed.
USE:
- Extend the cable completely before plugging
it in.
- Connect the appliance to the mains.
- Turn the appliance on, by using the on/off
button (1/a).
FAN FUNCTION:
- Select the desired ventilation speed by pres-
sing the speed selector button (3/c).
COOLING / HUMIDIFIER FUNCTION:
- Use the cooling botton (6/f), to activate this
function.
- To deactivate this function, follow the procedu-
re for switching it on in reverse.
- Do not activate this function if there is no water
in the tank, or if the water level is below the
minimum.
- When the water is low the pilot light will start
flashing.
- NOTE: It is highly recommended to use the
ice containers (J) (previously frozen) and cold
water to maximize the cooling function of the
appliance.
TIMER FUNCTION:
- The appliance's operating time can be control-
led (1-7h).
- To program the operating time simply select it
using the timer button (5/e).
- When the appliance is on stand-by mode, you
can set a timer to start the appliance.
- When the appliance is on, you can set the timer
to turn off the appliance.
- The time programmed will be indicated by the
pilot lights.
- After the selected time the appliance will switch
on or off automatically.
OSCILLATION FUNCTION:
- The oscillation function makes it possible to di-
rect the air flow from the apparatus, by turning
the vertical fins.
- To activate this function, press the oscillation
button (2/b).
- To deactivate this function, follow the procedu-
re for switching it on in reverse.
- You can also adjust the horizontal fins manu-
ally.
WIND MODES:
- This model has three wind modes:
- Normal: The fan operates constantly at the
selected speed.
- Breeze: The fan alternates periods of more
and less power, simulating the feeling of a soft
breeze.
- Night: The fan operates at speed 2 for 15 minu-
tes, and then it switches to speed 1 and keeps
running at that speed until it is turned off or the
timer runs out.
- To activate this function, press the modes
button (4/d).
- To deactivate this function, follow the procedu-
re for switching it on in reverse.
FILL UP / EMPTY THE WATER TANK:
- The water tank (E) is in the back-bottom part of
the appliance.
- Always turn-off and unplug the appliance from
the mains before undertaking these tasks.
- Turn the water tank buckle (F) to the horizontal
position (Fig 1).
- Unscrew the rotatory knob to separate the
water tank from the water pump and its pipe
(Fig 2.)
- After filling up the tank, install the water pump
in the tank. Insert the front hook into the slot in
the water tank and turn the knob so the pump
is fixed (Fig 3).
- Push the water tank in and lock it with the
buckle (F).
- To empty the water tank, use the same pro-
cedure to remove the water tank. Wait at least
two minutes after turning the appliance off, to
let all the water in the pipe or the evaporative
pad to come down to the tank.