Application; Casting With The Bd Cmt - BOOTDOC BD CMT Notice D'instructions

Application

6 Application
The BD CMT is designed for use with BOOT-DOC brand insoles only. Use with any

other insoles may result in permanent damage to your molding pillows and will void
your warranty.
 BOOT-DOC insoles are made from thermo-moldable high quality materials. BOOT-
DOC insoles should be heated to recommended temperatures (refer to BOOT-DOC
Website or catalogue) with BOOT-DOC Heating Devices. Never heat insoles above
recommended temperature or you may damage the molding pillows and/or insoles.
Do not attempt to open the molding pillows since it might cause permanent damage

and leaking. Any attempt to open the CMT box without authorization will void your
warranty.
Do not use any sharp implements on or near the molding pillows such as pens,

sharp fingernails, knives, etc.
The CMT is not a toy! Do not leave your molding system where customers or 

children can play with it.

7 Casting with the BD CMT

BD CMT
 Before you start to use the BD CMT make sure
the BD Wax is evenly distributed within the 
molding pillows.
1) Place the customer´s feet into the molding
pillows by holding the forefoot firmly and sliding
the heel into the back of the pillows heel pocket.
The forefoot should be allowed to fall naturally
in the general footprint area.
Position the molding pillows according to 
2)
customer's hip width. The key is to align the
center of the knee thru ankle joint and the foot´s
second toe.
-14-