Safety And Operating Instructions - Altas Copco LZB 77 A0017-15 Consignes D'utilisation Et De Sécurité

LZB 77 A0017-15
Safety instructions
Warning
Make sure you are familiar with the operating instruc-
tions before you use this motor.
This motor, its attachments and accessories must
only be used for the purpose for which they were
designed.
For product liability and safety reasons any
modification to the motor or its accessories, which
may have an influence on the product liability, must
be agreed upon by the technical authority of the
manufacturer.
To prevent personal injury and long term risks:
• If the motor is to be used in explosive environ-
ment filter/silencers must be installed at the
motor outlet ports.
Silencers are recommended also for other applic-
ations to reduce noice exposure.
• Before any adjustment operation – disconnect the
motor from the air line.
• Mind your hands, hair and clothing – always
keep well away from rotating parts.
Warning
T
WARNING Polymer hazard
The vanes in this product contain PTFE (a synthetic
fluoropolymer). Due to wear, PTFE particles might
be present inside the product. If heated PTFE can
produce fumes which may cause polymer fume fever
with flu-like symptoms, especially when smoking
contaminated tobacco.
Health and Safety recommendations for PTFE
must be followed when handling vanes and other
components:
Do not smoke when servicing this product
►
PTFE-particles must not come in contact with
►
open fire, glow or heat
Motor components must be washed with cleaning
►
fluid and not blown clear with an air line
Wash your hands before commencing any other
►
activity
General information
EC DECLARATION OF INCORPORATION
We Atlas Copco Industrial Technique AB, S-105
23 STOCKHOLM SWEDEN declare that this
product (with type and serial number, see front page)
must not be put into service until the machinery, in
which it is intended to be incorporated into or as-
sembled with has been declared in conformity with
EN
© Atlas Copco Industrial Technique AB - 9836 4468 00

Safety and operating instructions

the provisions of the Council Directive of 17 May
2006 on the approximation of the laws of the Mem-
ber States relating to machinery.
The product is in conformity with the appropriate
standard(s):
EN 1127-1:1997, EN 13463-1:2001
and in accordance with the following directive(s):
2006/42/EC (Annex I, clauses 1.1, 1.2 (excluding
1.2.4.3), 1.3, 1.4, 1.5, 1.6, 1.7, EN ISO 12100)
Technical file available from:
Quality Manager, Atlas Copco Industrial Technique,
Stockholm, Sweden
Stockholm, 1 July 2012
Tobias Hahn, Managing Director
Signature of issuer
RoHS and WEEE
Information concerning Restriction of Hazardous
Substances (RoHS):
This product and its information, meets the require-
ments of the RoHS Directive (2011/65/EU).
Information concerning Waste of Electrical and
Electronic Equipment (WEEE):
This product and its information, meets the require-
ments of the WEEE Directive (2012/19/EU), and
must be handled according to the directive.
The product and/or its battery are marked with a
crossed trashcan, see figure below.
The symbol indicates that parts within the product
must be handled in accordance with the WEEE
Directive. These parts are indicated as "WEEE" in
the Spare part list, see under Remarks.
The entire product, or the WEEE parts, can be sent
to your "Customer Centre" for handling.
For more information, consult the website
http://www.atlascopco.com/.
Choose Products - Links and downloads, and click
EU RoHS and WEEE directives (ENGLISH only).
Installation
Installation
Setting up, see figure in Service instructions.
3