auna PRO PW-EV-12A Mode D'emploi page 13

LED status light
1
Lights when the unit is switched on.
Mixer output (RCA) and line-in (RCA)
2
Connect playback devices such as CD players, smartphones, etc. here. Send the signal through the "Mix
Out" to an external mixing console
Balanced input (XLR)
3
Connect acoustic instruments, D.I. boxes or microphones here. Set the switch to the appropriate position
(input level adjustment) for line or microphone signals ("Mic").
2 microphone inputs (6.3mm jack)
4
Connect microphones or acoustic instruments here.
Sound and volume controls
Volume Total volume
Bass Bass control
5
Treble Treble control
Echo Share of the integrated echo effect
Mic Volume Proportion of the microphone signal in the overall sound
Connection for additional (passive) speaker (8 Ohm, SpeakOn)
6
Mains changeover switch
7
Set the supply voltage here (110V or 220V).
Power switch, mains connection
8
Connect the power cord here and switch the unit on/off.
Stand angle
9
Place the box on the supplied angles - as shown below - to achieve a "wedge" beam angle.
EN
13