English; Introduction; Safety Warnings - Omega SCOPE OMSP-2000 Serie Mode D'emploi

1

English

1.1

Introduction

This guide explains how to install the software, including the product manual,
from the CD-ROM supplied.
Once you have finished the installation, you will find that the product manual
contains much more information about setting up and using the product and
its software. The manual is installed in electronic format, but you can also
print a paper copy from the PDF file on the CD-ROM.
1.2

Safety warnings

We strongly recommend that you read the general safety information below
and also the product-specific safety warning in the product manual before
using your product for the first time. If you do not use the equipment in the
manner specified, then you may impair the protection provided. This could
result in damage to your computer or injury to yourself or others.
The product manual is installed on your computer when you install the
supplied software.
Maximum input range
You can find the maximum input range and, where applicable, overload
protection range in the product manual installed on your computer. Always
operate the product within the specified input range. Operation outside the
range of the overload protection is likely to cause permanent damage to the
unit. Incorrect configuration or use on voltages outside the maximum input
range can be hazardous.
Mains voltages
These products are not designed for use with mains voltages. To measure
mains, we recommend the use of a differential isolating probe that is
specifically designed for high-voltage measurements.
Repairs
The unit contains no user-serviceable parts. Repair or
calibration of the unit requires specialised test equipment and
must be performed by the factory.
M5063
USB Oscilloscope Quick Start Guide
1