Publicité
Les langues disponibles
Les langues disponibles
EG 0040
DRY AND WET VACUUM CLEANER 2x1000W
PROTECTION DEVICE
• When the water in the tank is full, the protective device will start up and the suction power
will disappear at that time. The vacuum cleaner then makes a noise indicating that the motor is
running at high speed. In this case, you must turn off the electricity and drain the water contained
in the filter before re-equipping the vacuum cleaner and turn it on. It will start working normally.
• Connect the vacuum cleaner ONLY to a 220-240 volt socket. 50 Hz.
• If the power cord is damaged, it must be replaced by the manufacturer or its service agent to a
qualified person to avoid danger.
• This equipment is not intended for use by persons (including children) with reduced physical,
sensory or mental abilities, and/or a lack of experience and knowledge, unless they have received,
for their safety, supervision or instructions regarding its use by a responsible person.
• Children should be supervised to ensure that they do not play with the device.
• The plug must be removed from the mains before cleaning or maintaining the unit.
DISPOSAL
• This device must not be disposed of with household waste throughout Europe.
• To ensure that uncontrolled disposal of waste does not harm the environment or human health,
recycle it responsibly to promote the recycling of material resources.
• To return your used device, please use the return and collection systems or contact the retailer
where the product was purchased.
WARRANTY
The manufacturer provides a one-year warranty from the date of purchase.
The warranty only covers defects in materials or workmanship.
Warranty repairs can only be performed by an authorized service center. When preparing a claim
under the warranty certificate, the original purchase invoice (with the date of purchase) must be
provided.
The warranty does not apply in the following cases:
• Normal wear and tear
• Incorrect use (e. g. overload of the device, use of non-approved accessories)
• Use of force, damage caused by external influences
• Damage caused by failure to comply with the operating instructions (e. g. connection to an
unsuitable area or failure to comply with the installation instructions).
• Partially or completely disassembled devices
Publicité
