Publicité
Les langues disponibles
Les langues disponibles
EG 0040
DRY AND WET VACUUM CLEANER 2x1000W
• CAUTION: If water comes out from the air outlet,
do not overturn the unit during repair to prevent
water from spilling into the engine and causing
damage.
• Turn off the vacuum cleaner and remove the plug
after each use or for any repairs.
• Keep the vacuum away from strong sunlight and
high temperatures to avoid deformation of the
plastic parts.
• Do not tear, pull or drag the hose to avoid damaging
it.
• Do not immerse or wash the tank cap with water in
case it reaches electrical parts and causes personal
injury. For cleaning: Immerse a cloth and turn it to
wring it out as much as possible. Then gently wipe
the dirty area.
• The vacuum cleaner should only be used by an
adult.
• When cleaning on stairs, take extra care as the
vacuum cleaner may tip and/or fall due to pipe
movements.
USE MODE
1. Connections :
• Insert the hose connector into the air inlet port as
shown in the picture opposite. Make sure that the
connector is properly attached.
• Connect all accessories as shown in the picture.
2. Check that the fi lter is properly in place before each
use.
3. Remove all tank components and the fi lter before
using it to suck up liquid.
4. Place the wireless power supply on the back of the
terminal connector when using the vacuum cleaner.
5. Connect the plug to the power supply.
6. Press the switch, the vacuum cleaner starts working.
Publicité
