Desa All-Pro SPC-54PHW Manuel D'utilisation page 5

4. Insert manifold into pole support (see Figure 2).
Insert the manifold assembly through the post by
passing through the hole in the post support. Note:
Make sure hose and regulator assembly attached
to manifold are never bent or kinked during instal-
lation and operation of heater.
5. Attach pole to pole support (Figure 3). Place
pole into pole support center connector.
Tighten six set screws with hex allen wrench
supplied with heater. Note: Set screws are
threaded inside post support.
6. Put propane/LP cylinder cover on base assembly
(see Figure 4). Slide propane/LP cylinder cover
over pole and pole support. Be sure that the pro-
pane/LP cylinder cover rests level on the base.
Pole
Support
Legs
Base
Ballast
Weight
Figure 1 - Base Assembly
114144-01G
Pole
Support
Figure 2 - Installing Manifold Assembly
www.desatech.com 5