Publicité
SEE INDIVIDUAL PELLET GUIDE FOR INSTALLATION OF THE TWO
FAN LIMITS if you have purchased the PELLET option. The
electonic fan limit is included with the pellet components.
INSTALLING THE FAN LIMIT
ONLY FOR WOOD, WOOD-
ELECTRIC OR ADD-ON. DIFFERENT
IF PELLET OPTION
Step 15:
Choose the side on which the
fan limit will be installed (two
pre-drilled holes).
The plenum must be in place.
Drill a hole with a 1" drill bit
in
the
plenum
at
appropriate place to receive
the fan limit element tube.
See instructions below and
use
if
wanted
drilling
template on last pages.
Step 17:
Fix towards TOP, the fan limit electrical
wire
using
wire
clips
Unscrew screws from top and side
casing of the device to bring the
electrical wire above the ventilation
box. Insert excess wire in wire hiding-
cover (see step 13).
Beginning
of plenum
Fan limit
location
Furnace
front side
INSTALLATION OF THERMOSTAT see page 4
L.S. Bilodeau inc.
the
provided.
Mechanic fan limit (INSTALLATION WOOD OR WOOD-ELECTRIC OR ADD-ON ONLY)
2-5/8"
4-1/2"
SEE DRILLING HOLE TEMPLATE LAST PAGE
CHOICE TO DRILL HOLE IN PLENUM ON EITHER SIDE OF
FURNACE. THE MECHANIC FAN LIMIT WILL BE AT 2-5/8"
(front furnace) BEGINNING OF PLENUM, FOR EITHER RIGHT
SEE PREVIOUS STEPS and drilling hole TEMPLATE last two
281 Route 108 Est, Saint-Éphrem-de-Beauce, Quebec G0M 1R0
Tel.: 418 484-2013 ▪ Fax: 418 484-2014 ▪
Step 16:
Insert the element tube
into the opening and
fasten with the four (4)
screws provided, the fan
limit to the plenum and to
the furnace.
Position the tab on AUTO to be in heating
mode.
In position «MAN», the fan will blow
continuously. (Summer speed)
Step 18:
Connect the fan limit on
the vent box where
indicated «Fan limit».
DUCT
Drill a 1" hole
FURNACE RIGHT SIDE ILLUSTRATED
OR LEFT SIDE.
pages
www.lsbilodeau.com
Do not use THIS DIAGRAM IF
PELLET OPTION, SEE INDIVIDUAL
PELLET GUIDE ON PAGE 40
5-1/8"
6 /10
Publicité
