Publicité
INSTALLATION OF
COMPONENTS
DANGER: Risk of electric shock when connecting electrical components
READ CAREFULLY THE INSTALLATION, MAINTENANCE AND USER MANUAL.
IMPORTANT: These instructions are for the exclusive use of licensed service technicians, to which the responsible authorities
have issued the necessary licence and which are the only ones authorized to do the maintenance and repairs to the AirBilo
furnace and it's different components. Above all it is important to remember that all system components can influence the proper
and safe operation of this appliance and that the service technicians must be familiar with the particularities of the appliance
before proceeding with any troubleshooting or repair.
COMPONENTS SUPPLIED WITH AirBilo FURNACE
Check the box of parts supplied with the furnace AirBilo
A. 1 thermostat
B. 1 damper motor
C. 1 damper motor chaine
D. 1 fan limit
1-
Tools needed for installation
•
Screwdriver #2 (Philipps) or drill with screwdriver bit #2
FOLLOW THE INSTALLATION INSTRUCTIONS FOR THE FURNACE (Steps 1-10) OF THE USER'S MANUAL
BEFORE INSTALLING COMPONENTS.
INSTALLING THE DAMPER MOTOR (B and C)
Step 11:
Fasten using the two (2)
screws provided the
damper motor above right
of air shutter.
(pre-drilled holes)
Attach one end of the chain
in the wheel of the damper
motor where indicated.
Step 13:
Fix towards TOP, the damper electrical
wire
using
wire
clips
Unscrew two (2) screws from casing of
the front device and two (2) screws on
the side and one (1) on back to bring
the electrical wire above the ventilation
box. Insert excess wire in wire hiding-
cover of the vent box. See also
individual guide AirBilo Control panel.
L.S. Bilodeau inc.
OF THE AirBilo FURNACE
Can cause injury or death
Disconnect sources of supply prior to servicing
E. 1 bag of including:
• 8 electrical wire clips
• 10 screws: 1/2"
• 10 screws: 1"
provided.
281 Route 108 Est, Saint-Éphrem-de-Beauce, Quebec G0M 1R0
Tel.: 418 484-2013 ▪ Fax: 418 484-2014 ▪
COMPONENTS
B.
Step 12:
Hook the other end of the
chain to the cover of the
air flap.
Make sure the lid of the
air flap opens freely to a
minimum of 1" and
CLOSES IN A SEALED
WAY.
www.lsbilodeau.com
D.
A.
E.
C.
Step 14:
Connect the
damper motor
on the
ventilation box
where indicated
Volet / Shutter.
5 /10
Publicité
