Silverline 811388 Traduction Des Instructions Originales page 9

811388
Driving
1. Select the chosen bit in the Bit Cylinder (10) and insert into the Bit Holder (1) (see 'Selecting a
screwdriver bit')
2. Set the Clockwise/Trigger Lock/Anti-clockwise Switch (5) button to either clockwise or anti
clockwise (Image D)
3. Connect the bit to the end of the screw/fastener and pull the Trigger (9) to power the tool
4. Release the Trigger when the screw/fastener has reached the desired depth or has been removed
from the workpiece
Note: It is recommended that a pilot hole be used when driving screws/fasteners.
Accessories
• A range of accessories, including bits and fasteners, is available from your Silverline stockist
• Spare parts can be purchased from toolsparesonline.com
Maintenance
WARNING: Ensure the Trigger (9) is locked before performing maintenance.
General inspection
• Regularly check that all the fixing screws are tight
• Inspect the supply cord of the tool's charger, prior to each use, for damage or wear. Repairs
should be carried out by an authorised Silverline service centre. This advice also applies to
extension cords used with this tool
Cleaning
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly, and
shorten the machine's service life. Clean the body of your machine with a soft brush, or dry cloth.
If available, use clean, dry, compressed air to blow through the ventilation holes
• Clean the tool casing with a soft damp cloth using a mild detergent. Do not use alcohol, petrol
or strong cleaning agents
• Never use caustic agents to clean plastic parts
Lubrication
• Slightly lubricate all moving parts at regular intervals with a suitable spray lubricant
Contact
For technical or repair service advice, please contact the helpline on (+44) 1935 382 222
Web: silverlinetools.com/en-GB/Support
Address: Powerbox, Boundary Way, Lufton Trading Estate, Yeovil, Somerset, BA22 8HZ,
United Kingdom
Storage
• Set the Clockwise/Trigger Lock/Anti-clockwise Switch (5) to the Trigger Lock position before
storing (Image D)
• Store the tool with a full battery charge. Recharge the tool every 3 months if stored long term and
not used, which will preserve the battery life
• Store this tool and its accessories carefully in a secure, dry place out of the reach of children
• Store out of direct sunlight
Disposal
Always adhere to national regulations when disposing of power tools that are no longer functional
and are not viable for repair.
• Do not dispose of power tools or other waste electrical and electronic equipment (WEEE) with
household waste
• Contact your local waste disposal authority for information on the correct way to dispose of
power tools
3.6V Cordless Screwdriver
silverlinetools.com
9