Publicité
14
LEGEND L10/L6
LEGEND L10/L6 Getting Started
Step 3: Network
Connection
make up your system. Use two screws to
secure them to the front top and bottom
rails of the L6 or L10. Carefully read the
instructions for your modules so you know
the correct operation and follow the
recommended connections.
dirt, dust and other objects from entering
the unit.
power cord to the L6 or L10.
Be careful that any 48V phantom power
switches are correctly set, because some
microphones and audio devices can be
damaged permanently by phantom power.
With the power cord
Set the power switch to the
unplugged from the L6 or
Up position and observe that
L10, install the various
the front panel power lamp
500-series modules that
is illuminated, indicating
that the system is ready for use.
Although the L6 and L10
have a rear panel Ground Lift
switch, it is recommended
that you only use it as a
temporary last resort. The cause of ground
Blank spaces in your L6 or
loop hums etc should be carefully
L10 can be fi lled using the
investigated and eliminated correctly,
MIDAS L1B blank plates.
rather than use this temporary measure.
These plates will prevent
The ground lift switch does not aff ect the
safety ground connection to the chassis,
which is always present.
When all connections are
made, and the appropriate
switches set on the rear
panel, connect the supplied
Some microphone
preamplifi er modules off er
+48V phantom power if
your microphone needs it.
Quick Start Guide
15
Publicité
