M-Spa B-090 Manuel De L'utilisateur page 17

7. Spa Bladder Inflation (*Optional for MSpa LITE)
7.1 Open the air valve (a) on the bladder. Insert the
inflation hose (b) into the valve.
7.2 Press the Bubble
it is firm to touch but not hard.
7.3 Press the Bubble
inflation. Disconnect the inflation hose from the
air blower outlet and the valve
7.4 Replace the air valve cap (c) back on the control
panel. Close and recess the inflation valve (a).
NOTE: Deflation Instruction
Spa Deflation
1. Unscrew the air valve cap on the spa pool to deflate the spa.
2. Once the deflation is completed, replace the cap back.
Spa Bladder Deflation (*Optional for MSpa LITE)
1. Pull the valve cap out and squeeze the valve at its base until deflated.
2. Close and recess the valve back.
8. Water Filling
8.1 Check the spa liner is at the selected area and
point the drain valve toward a suitable draining
area before inflation.
8.2 Fill the spa tub with fresh water to a level
between Minimum and Maximum line marked
on the inside of the spa wall. Do not over fill
the spa. It is recommended to fill the spa with
lukewarm water for quick heating and energy
saving.
WARNING:
:DWHU OHYHO PXVW UHDFK WKH Minimum water line but not exceed the Maximum line to avoid
pump failure.
1HYHU SRXU ZDWHU ZLWK D WHPSHUDWXUH KLJKHU WKDQ ƒ) ƒ& LQWR WKH VSD GLUHFWO\
7R DYRLG FRQWURO V\VWHP IDLOXUH GR QRW RSHUDWH WKH VSD XQWLO ZDWHU UHDFKHV WKH Minimum
line.
8.3 After water filling, double check the spa pool air pressure to makes sure the manometer points out
the Green section.
8.4 Place the inflated air bladder and the zipper spa cover over the spa tub, and make sure the spa
cover zipper are closed and lock the cover by the digital lock in the accessory pack.
IMPORTANT:
,QVSHFW WKH VSD SUHVVXUH UHJXODUO\ IRU OHDN SUHPDWXUH ZHDU RU GHWHULRUDWLRQ
&KHFN DQG ZD[ WKH ]LSSHU UHJXODUO\ WR PDNH LW VPRRWK IRU RSHUDWLRQ DQG DYRLG VSOLWV
button to inflate until
button again to stop
17
7
(b)
(a)
8
(c)