Stanley ST-302-231-E Guide D'utilisation page 18

RISK OF ELECTRIC SHOCK! DISCONNECT FROM POWER BEFORE MAINTENANCE.
WARNING
NOTE: This section only applies to heaters sold or used in Great Britain.
NOTE: This plug only applies to models ST-302-231-E / ST-303-241-E
This appliance is supplied with a BS1363A
3 pin plug fitted with a fuse. Should the fuse
require replacement, it must be replaced with a
fuse with the proper amp rating. (see Technical
Specifications page 2) and approved to BS1362.
In the event the mains plug has to be removed/
replaced for any reason, please note:
IMPORTANT: The wires in the mains lead are
colored in accordance with the following code:
Blue – Neutral
Green/Yellow – Earth
As the colors of the wires in the mains lead of this
appliance may not correspond with the colored
markings identifying the terminals in your plug,
proceed as follows:
Figure 3
© 2016, Obelis S.A Registered Address: Bd.
Général Wahis, 53
1030 Brussels, Belgium
Plug Replacement
Brown – Live
Plug Replacement Wiring Diagram
BLUE
Neutral
CORD CLAMP
The blue wire must be connected to the terminal
marked with an N or colored black. The brown
wire must be connected to the terminal marked
with an L or colored red. The green/ yellow wire
must be connected to the earthing terminal which
is marked with an E or with the earth symbol.
WARNING
the plug.
NOTE: If a moulded plug is fitted and has to
be removed take great care in disposing of the
plug and severed cable, it must be destroyed to
prevent engaging into a socket.
GREEN / YELLOW
Earth
17
Never connect live or neutral
wires to the earth terminal of
BROWN
Live
FUSE
13 Amps