Fenton SBS30 Manuel D'instructions page 5

MUSIC PLAYBACK VIA CD+G, USB AND AUX-IN
Getting Started
•
Connect your unit to a compatible TV using the included A/V cable.
•
Plug in the included microphone into either the MIC 1 or MIC 2 jack. Note: Always set the mic to OFF until you are
ready to sing to avoid possible sharp feedback noises.
Singing along with CD+G, CD, CD-R/CD-RW or USB Flash Drive
Set the FUNCTION selector to "CD".
1.
2. Load a CD/CD+G disc as follows: Grip the top front edge on the CD door where indicated and pull gently to open it.
The LED display will display "OP". Load a disc vertically into the compartment with the printed side facing you. Gently
close the CD door. The unit begins to read the disc.
The LED display will display the total number of tracks. (If no disc is loaded or the disc cannot be recognized, "No" will
3.
be displayed in the LED display). When a CD+G disc is detected and being played, the CDG indicator in the LED
display will light.
4. Press PLAY/PAUSE button to play the disc. If a CD+G track is being played, the following TV screen will appear:
NOTE: If you try to play a self-compiled CD-R/RW disc or USB flash drive with MP3 songs (both are not included), you will see
the following menu instead:
On the top line of the menu, "T: 011/118 means track #11 out of total 118 tracks is now playing. The elapsed time of current
track is shown on the right.
BT OPERATION
Slide the FUNCTION SELECTOR to the right, selecting CD. Press and hold the STOP/BT button to enter BT mode. If
successful, "bt" will flash on the display. Turn on the BT function of the device you want to pair to the SBS30 Karaoke System.
If a password is required, enter "0000". After successfully pairing the SBS30 Karaoke System with your device, "bt" will stop
flashing, but remains on the display.
5