Axis Q7411 Mode D'emploi page 10

AXIS Q7411 Video Encoder
How to reset to factory default settings
Important
Reset to factory default should be used with caution. A reset to factory default resets all
settings, including the IP address, to the factory default values.
To reset the product to the factory default settings:
1. Disconnect power from the product.
2. Press and hold the control button and reconnect power.
3. Keep the control button pressed for 15–30 seconds until the status LED indicator flashes
amber.
4. Release the control button. The process is complete when the status LED indicator turns
green. The product has been reset to the factory default settings. If no DHCP server is
available on the network, the default IP address is 192.168.0.90
5. Using the installation and management software tools, assign an IP address, set the
password, and access the video stream.
The installation and management software tools are available from the support pages
at axis.com/support
It is also possible to reset parameters to factory default via the web interface. Go to Setup >
System Options > Maintenance and click Default.
10