Publicité
Les langues disponibles
Les langues disponibles
UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
DMX-512 CONNECTION
If you are using a standard DMX controller, you can connect the DMX-output of the controller directly to the DMX-input of the
first unit in a DMX-chain. Always connect the output of one unit with the input of the next unit until all units are connected.
If you use a controller with 5 pin DMX connection you will need to use a 5-pin to 3-pin adapter.
Fixture number
Default DMX starting address
1
1
2
33
3
65
4
97
5
129
6
161
7
193
8
225
9
257
10
289
11
321
12
353
At the last fixture, the DMX cable has to be
terminated. Solder a 120 Ohm resistor between
signal (-) and signal (+) into a 3-pin XLR
connector and plug this into the DMX output of the
last fixture in the chain.
3-Pin XLR to 5-Pin XLR Conversion
Conductor
Ground/Shield
Data
Compliment (-
signal)
Data True (+
signal)
Not Used
Not Used
Binary dipswitch settings switch to the "on position"
1
1, 6
1, 7
1, 6, 7
1, 8
1, 6, 8
1, 7, 8
1, 6, 7, 8
1, 9
1, 6, 9
1, 7, 9
1, 6, 7, 9
3-Pin XLR
5-Pin XLR Male
Female
(In)
(Out)
Pin 1
Pin 1
Pin 2
Pin 2
Pin 3
Pin 3
Pin 4 – Do Not
Use
Pin 5 – Do Not
Use
3
Publicité
