Napa 6-1028 Guide D'utilisation page 6

OPERATION
• Always use the
recommended
wheel guard to
prevent injury
from broken
grinding wheel
parts. If a guard has
withstood a wheel
breakage, discontinue its
use. It may be damaged.
Position the guard
between the grinding
wheel and the operator.
Use barriers to protect
others from wheel
fragments and grinding
sparks.
• Always wear impact­
resistant eye and face
protection when involved
WARRANTY POLICY: NAPA
PROFESSIONAL AIR TOOLS are
warranted against defects in
material and workmanship for a
period of one (1) year from the
date of the original purchase. We
will repair or replace at our option
any defective part or unit which
proves to be defective in material or
workmanship during this one year
period. All NAPA PROFESSIONAL
AIR TOOLS must be repaired only
by authorized NAPA PROFESSIONAL
AIR TOOLS Service Centers. This
warranty does not cover damage to
PLEASE REVIEW ALL WARNING INSTRUCTIONS PRIOR TO OPERATION. SAVE ThIS mANUAL fOR fUTURE REfERENCE.
6-1028
in the
operation of
this tool. Even
small projectiles
can injure eyes
and cause blindness.
A grinding wheel that
bursts can cause very
serious injury. Never use a
grinding wheel marked
with a speed lower than
the air grinder speed.
• Before grinding, test
grinding wheel by briefly
running the tool at full
throttle. Be sure to use a
barrier (such as under a
heavy work table) to stop
any possible broken wheel
parts.
tools rising from alteration, abuse,
misuse and does not cover any
repairs made by anyone other than
an authorized NAPA PROFESSIONAL
AIR TOOLS Warranty Center. Tools
sent to a Warranty Center in a
dissembled condition will not be
covered as a warranty repair.
Return tools to Service Centers
transportation prepaid. Be certain
to include your name, address and
phone number along with proof
of purchase information,
with each tool.
6
To Change Grinding Discs:
1. Use stop spanner (#43) to
hold spindle (#36).
2. Use hex­ wrench (#44) to
remove screw (#38) and
grinding disc wheel.
3. Attach grinding disc wheel
to be used and reattach
screw (#38) with hex­
wrench (#44). Tighten.
S
pecificationS
Max­ Free Speed .............. 19,000 RPM
Air Inlet .......................... 1/4" NPT
Min. Hose Size ............... 3/8" ID
Avg. Air Cons. ................ 2.6 CFM
Rec. Air Pressure ............. 90 PSIG (6.2BAR)
Weight. .......................... 1.21 LBS.
Length ............................ 5.7"
Spindle Thread Size ........ M6x­1.0mm
02/14/08