Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
DESCRIPTION OF THE REMOTE
The remote control operates via radio waves. You don't need to point it towards the BOREA BT
speakers to control them.
1. Power on / Standby
2. Increasing the volume
3. Previous Track*
4. Turning volume down
5. Change input / «BTC»
1
The «BTC» function allows you to disconnect the
currently connected BT source:
- Quickly pressing the button : : Source selection
- Pressing and holding for 3 secondes the button:
Disconnect the Bluetooth source
1
2
3
*
4
5
6
* Only with Bluetooth
(1) (2) (3)
See the indications on the next page
6. Reset bass and treble adjustment
7. Mute / «Dimmer»
2
8. Next Track*
9. Play/pause a track*
10. Decreasing or increasing treble
11. Decreasing or increasing bass / Turning
ON or OFF «Loudness»
3
7
8
*
9
*
11
10
REMOTE CONTROL
Model: TEA02-C,TEA02-B ,TEA0
2-AZ,TEA02- BB,TEA02-BA,
TEA03- C,TEA03-B ,TEA03-AZ,
TEA03-BB,TEA03- BA, TEA04-
C,TEA04- B,TEA04-AZ,TEA04-
BB, TEA04-BA
Frequency Range:
2464MHz 2.RF
Output Power:
3.87dBm (EIRP)
26
OPTIONS ON THE REMOTE CONTROL
1- DIMMER
The DIMMER function allows you to deactivate the indicator light on the front of the active speaker.
Press and hold the «MUTE» button for 3 seconds. The indicator light will only blink when using the
remote control. It will also be active when the speakers are in standby mode.
2- LOUDNESS
At low volumes, we hear the low frequencies differently than at medium or high volumes. This
function balances the low frequencies at low volume and adapts gradually when the volume
changes. It is particularly recommended when listening to ambient music.
The LOUDNESS function adapts to the speaker volume.
3- BTC
This function allows you to disconnect a Bluetooth source to connect a new one. To do so, press
and hold the button for more than 3 seconds to activate this function when using the Bluetooth
input of the BOREA BT. The indicator light on the front panel should now blink blue.
You can use your smartphone, tablet, or computer to select the BOREA BT in the list of available
Bluetooth devices.
PAIRING PROCEDURE
The remote control for your BOREA BT speaker is radio-controlled and factory-paired with the
speaker. If the remote is not working or if you have a new one, you need to pair the remote control.
Please turn ON the speaker with the back panel switch and wait for 3 seconds. Press continuously
«EQ reset» button on the remote for 5 seconds while watching the speaker LED on the front panel.
This LED will blink a couple of time after successful pairing (within a few seconds).
27
EN
Publicité
Table des Matières
