Sony WAHT-SD1 Mode D'emploi page 12

Installing the IR receiver on a
wall
1
Install a commercially available screw
in the wall so as to protrude 4 mm (
inch).
5 to 7 mm
7 9
( / to /
32 32
(
2
Detach the IR receiver stand and hang
it by the hole on the rear of the IR
receiver on the screw.
Make sure that the IR receiver does not
move after installation.
IR receiver
IR receiver stand
Tip
• When reattaching the IR receiver stand to the IR
receiver, attach the stand so that both delta marks on
the IR receiver and stand are aligned.
12
GB
inch)
4 mm
3
/ inch)
16
3
/
16