Kolpin POLARIS RANGER 400 Instructions D'installation page 2

Over-tightening any and/or all screws will cause cracks around mounting holes which is not covered by any
b) Install the windshield to all clamps using supplied hardware (Item D)
without applying final torque. Adjust the position of the windshield and
tighten all screws with specified torque indicated below. Ensure that the
windshield is perfectly level before tightening. Over-tightening clamps to
roll bar could cause parts failures.
Shoulder
washers
M6
Philips truss
screws
M6 x 12
2. Maintenance and Care
Tighten all hardware after first use and periodically thereafter.
 Rinse with lukewarm water; wash gently with mild soap or detergent and lukewarm water, using a soft cloth or sponge. DO NOT SCRUB
 To remove wet paint, glazing compound or grease, rub lightly with a good grade of VM&P naphtha or isopropyl alcohol, then wash and
NOTICE: Abusive cleaning procedures by hand washing or automated washing equipment will eventually result in visual hazing, loss of
Recommended products: Johnson Paste Wax, Novus Plastic Polish #1 and #2, Mirror Glaze plastic polish and Plexux1.
Testing polish on a separate Lexan sample is recommended. Be sure to follow product instructions carefully.
2732 - Instructions POLARIS RANGER 400 Rear Windshield GP - rev01
IMPORTANT NOTICES
Torque specifications must be followed when tightening bolts.
Philips truss screws
M6 x 12
Shoulder
washers M6
 Rinse again. Dry with soft cloth or moist cellulose sponge to prevent water spotting.
light transmission and coating delamination.

Aqueous Solution of Soaps and Detergents
Joy Freon T.F. Palmolive liquid
MINIMIZING HAIRLINE SCRATCHES
For minimizing scratches and minor abrasions, mild automobile polish can be used.
warranty.
Plastic
washer
M6
CLEANING:
or use brushes or squeegees.
rinse. DO NOT USE GASOLINE.
Compatible Cleaning Agents
Top Job
IMPORTANT :
Torque specification
Max. 5 foot-pounds
Applicable to all
Clamp screws M6 x 20
(If torque tools are not
available, stop tightening as
soon as both male and
female clamp parts touch as
per picture below.)
VM&P grade Naphtha Windex
(with ammonia D)
www.kolpin.com
2