Philips QC5053 Mode D'emploi page 11

Disposal of the battery
Only remove the battery if it is completely empty.
1 Disconnect the appliance from the mains and let the appliance run
until the motor stops.
 Push the middle part of the cutting unit upwards with your thumb
until it opens and then pull it off the appliance (Fig. 9).
Be careful that the cutting unit does not fall to the floor.
 Remove the upper housing part from the inner part of the
appliance by means of a screwdriver (Fig. 15).
 Separate the lower housing part from the appliance (Fig. 16).
5 Remove the battery by prying it out of the appliance (Fig. 17).
6 Cut the wires and dispose of the battery in an environmentally safe
way.
Do not connect the appliance to the mains again after it has been
opened.
guarantee & service
If you need service or information or if you have a problem, please visit
the Philips website at www.philips.com or contact the Philips Consumer
Care Centre in your country (you find its phone number in the
worldwide guarantee leaflet). If there is no Consumer Care Centre in
your country, go to your local Philips dealer.
4203.000.5451.4.indd 11
English
11
20-11-2008 14:02:54