Publicité
Les langues disponibles
Les langues disponibles
GLUE mode:
On the SETTINGS screen below, the user can specify the presence glue between the panels/sheets. When this mode is in use, a pre-spot is performed
before the weld. The duration of this pre-spot is set in milliseconds, from 0 to 400 ms, with 50 ms thresholds. When the glue mode is selected, la
word « GLUE » is displayed in the menus of the NORMAL, MANUAL, MULTI or GYSTEEL welding modes.
USE OF THE GUN
- Connect the earth pad to the terminal on the generator.
- Fix the earth pad firmly and as close to the weld as possible.
In the case of a monopoint weld, always place the earth on the sheet/panel that is not in contact with the welding electrode (in order for the current
to go through the two sheets to be welded).
- Weld starting with the furthest spot away from the earth and work towards it.
- Select the GUN tool using the button
- The normal welding mode using the stars is the one used by default.
- The gun can be used in normal or manual mode.
Never leave the inertia hammer at the end of the gun when it is hanging from the over-hanging arm. Risk deterioration of the cables.
GYSPOT BP GENIUS
GYSPOT BP GENIUS
Ce menu est accessible en pressant la touche
La langue des menus peut être sélectionnée en ligne 1.
La date et l'heure peuvent être programmées en ligne 2.
Les modes GYSTEEL, CONSTRUCTEUR, AUTO, ENERGY, NORMAL et MULTITOLES peuvent être activés / désac-
tivés dans ce menu.
KA/daN control :
This menu is used to indicate the size of the circuit-breaker installed on the device's supply line.
Once informed, the device will limit the welding rate in order to avoid tripping the circuit-breaker.
5 choices are possible:
- 32 A
- 40 A
- 50 A
- ON (the device does not limit the welding rate)
- OFF (the device does not limit the welding rate and does not display an error message in the welding report)
If the limit welding rate is exceeded, the device refuses to perform the operation and displays the following
message
, or by pushing.
In normal mode, the gun will be limited to 1.5mm thick sheets.
Using the gun, the operator can choose between different tools (mono point, star, impact, heat, dowel pin,
rivet, nut, toothed wheel). Select the desired tool using the + and - keys.
In Manual mode, the maximum possible intensity is 9 kA for a maximum duration of 600 ms. The settings
showing on the screen will not exceed these values.
Set the generator by indicating the thickness of the sheet/panel to weld using + and - keys. It is possible to
adjust the current and time settings when in manual mode.
pendant plus de 2 secondes.
EN
45
Publicité
