TaoTronics SOUNDSURGE 46 Mode D'emploi page 4

EN
Package Contents
·1 x TaoTronics Wireless ANC Headphones
·1 x USB Charging Cable
·1 x 3.5mm Audio Cable
·1 x User Guide
·1 x Airline Headphone Adapter
·1 x Carrying Case
How to Use
1. Charging
1) Connect the charging port with any USB charging adapter.
2) Charging will start automatically with the charging indicator turning red.
3) The headphones are fully charged when the charging indicator turns off.
Note:
·For quick charging, you need to use a DC 5V charger with more than 1A.
2. Pairing
1) Make sure the headphones and your Bluetooth® device are next to each other (within 3ft / 1m).
2) Press and hold the Power Button for 5 seconds to bring the headphones into pairing mode
with the power / Bluetooth indicator flashing blue and red alternately.
3) Activate Bluetooth® on your device and search for nearby Bluetooth® connections.
4) Find"TAOTRONICS SoundSurge 46"in the search results. Tap on the name to connect. Once connected,
the LED indicator will flash blue once every 3 seconds.
Note:
·The Bluetooth® headphones can remember devices paired previously. You may simply turn on the
headphones and the device (with Bluetooth activated), and they will connect to the last connected
device automatically without going into the pairing mode.
·To clear the pairing history, Disconnect on your device, and then press and hold the Power and
Volume - Buttons simultaneously when the headphones are on until the Bluetooth indicator flashes purple.
Button Functions
Function Operations
Power on / off Press and hold the Power Button until the power / Bluetooth
indicator flashes / turns off.
Play / Pause / Press the Power Button once.
Answer / Hang up Phone Calls
Reject Phone Calls Press and hold the Power Button for 3 seconds.
Mute the Call / Music Press Volume + and Volume - Buttons at the same time
Redial Press the Power Button twice.
Volume + / - Press the Volume + / - Button
Previous / Next Track Press and hold the Volume - / + Button
Bluetooth Pairing Press and hold Power Button for 5s when off
Note:
·The headphones will prompt low battery with the charging indicator light flashing red once every 5s
and shut off automatically if battery gets too low.
·The headphones shut off automatically after 10 minutes when no device is connected.
·Switch the ANC Button to turn on / off the active noise cancellation (ANC) function and the built-in
indicator will light up green / go out.
·Connect the headphones to a 3.5mm audio port with the audio cable provided and you may apply
it with wire.
01/02