Wagan Tech Smart AC 150 USB+ Guide D'utilisation page 6

Smart AC 150 USB+
®
Troubleshooting
When operating a TV monitor, TV/DVD, or TV/VCR combination,
picture tube type TVs and monitors have a high initial surge of power
when they are turned on. If the device does not start up on the first try,
switch the device on every 2-3 seconds until the screen comes on. Some
screens may take 2-5 tries before starting.
If the inverter does not appear to be functioning, check the following
possible causes:
• Poor contact : clean contact parts thoroughly.
• DC receptacle has no power: check fuse in lighter socket circuit
and replace any blown fuse with same type and rating.
• Battery voltage is too low: start the engine or recharge the
battery. Replace
battery if needed.
• Shuts down on overload: reduce the wattage of the load.
• Thermal shutdown: under heavy loads for extended periods of
time, the inverter will shut down to prevent damage from excess
heat. Reduce the load and allow the inverter to cool before
restarting the inverter.
Maintenance
Little maintenance is required to keep your inverter operating properly.
Periodically clean the exterior of the unit with a damp cloth to prevent
accumulation of dust and dirt.
5
by Wagan Tech
™
www.wagan.com
®