YT Industries JEFFSY RTFM Mode D'emploi page 5

HANDLEBAR ASSEMBLY
R E N T H AL A P EX C A RB O N 3 5
Remove the cable ties using a wire cutter. Grease the threads of the screws and put
2.1.1 2.1.2
Remove the stem screws and put them aside them in the handlebar clamps.
(Allen key 4 mm).
Start with the lowermost bolts, torqueing Make sure the clamp gap of the upper screws
2.1.5
2.1.4
down the bottom part of the stem clamps ac- is even and the handlebar is centered and
cording to the manufacturer's specifications. inserted correctly. The adjustment lines will
Take care not to leave a gap here (zero gap). help you with this. The torque of the screws
Only then should you secure the handlebar should fit the handlebar and / or stem manu-
with the upper bolts as well. facturer's guidelines.
0 8 y t
Attach the clamps to the stem (Allen key
2.1.3
4 mm). Please make sure the handlebar
clamps are aligned correctly.
P l ea s e f o l l o w t h e
t o r q u e s pec if ic at io n s o f
t h e ma n u fac t u re r s :
Renthal Apex:
Steerer tube screws // 5 Nm
Handlebar clamp screws // 5 Nm
HANDLEBAR ASSEMBLY
Remove the cable ties using a wire cutter. Install the handlebar. Mount the handlebar to
2.2.1 2.2.2
Remove the stem screws and put them aside the stem.
(T25 Torx).
Make sure that the clamp gaps under the low-
2.2.4
er stem bolts are even, and that the handlebar
is correctly centered and aligned in the stem
– there are markings to assist you with this.
Torque all bolts precisely to the spec indicated
by the stem and/or handlebar manufacturer.
E1 3 PL US
Start with the uppermost bolts, torqueing
2.2.3
down the top part of the stem clamps ac-
cording to the manufacturer's specifications.
Take care not to leave a gap here (zero gap).
Only then should you secure the handlebar
with the lower bolts as well.
P l ea se f ol l ow t h e
t o rq u e sp e c i fi c at i on s of
t h e m a n u fac t u rer s:
E13 Plus:
Steerer tube screws //
Handlebar clamp screws //
5 – 7 Nm
5 – 7 Nm
y t 0 9