miogo MHI801SH Notice D'utilisation page 80

Problem
Automatic Heat Up does not
operate.
The heat setting changes be‐
tween two levels.
The sensor fields become hot.
There is no sound when you
touch the panel sensor fields.
comes on.
comes on.
and a number come on.
You can hear a constant beep
noise.
8.2 If you cannot find a
solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre. Give the data from the rating
36 ENGLISH
Possible cause
You use a very tall pot which
blocks the signal.
The zone is hot.
The highest heat setting is set.
Power management operates.
The cookware is too large or you
put it too near to the controls.
The sounds are deactivated.
Child Safety Device or Lock oper‐
ates.
There is no cookware on the
zone.
The cookware is unsuitable.
The diameter of the bottom of the
cookware is too small for the
zone.
There is an error in the hob.
The electrical connection is incor‐
rect.
plate. Give also three digit letter code for the
glass ceramic (it is in the corner of the glass
surface) and an error message that comes
on. Make sure, you operated the hob
correctly.
Remedy
Use a smaller pot, change the cook‐
ing zone or operate the hood man‐
ually.
Let the zone become sufficiently
cool.
The highest heat setting has the
same power as the function.
Refer to "Daily use".
Put large cookware on the rear
zones, if possible.
Activate the sounds. Refer to "Daily
use".
Refer to "Daily use".
Put cookware on the zone.
Use suitable cookware. Refer to
"Hints and tips".
Use cookware with correct dimen‐
sions. Refer to "Technical data".
Deactivate the hob and activate it
again after 30 seconds. If
comes on again, disconnect the hob
from the electrical supply. After 30
seconds, connect the hob again. If
the problem continues, speak to an
Authorised Service Centre.
Disconnect the hob from the electri‐
cal supply. Ask a qualified electri‐
cian to check the installation.