Schwaiger DiSEqC 9 Instructions De Montage page 11

2.0. Multiswitch Control
The multiswitch can be controlled either by way of the usual analog switching media or by way
of DiSEqC commands.
- Activating the multiswitch by means of the usual analog switching media provides
access to max. two frequency bands. (LNB1/low - LNB1/high)
- Activating the multiswitch by means of the DiSEqC commands provides access to all four
frequency bands (group address of the multi-switch= 10 H/ direct address of the multi-
switch=14H).
Type of receiver applied
Tone burst receiver
DiSEqC receiver level 1.0 or 2.0
3.0. Installation Instructions
The currently valid safety requirements must be observed!
(See enclosed sheet of instructions „Important Safety Hints")
3.1. LNBs
Two Universal Quattro LNBs can be used as input systems for the reception of analog and
digital programs from two SAT positions (e.g. Schwaiger SPS 6918).
In order to receive analog programs from four SAT positions, four TWIN LNBs
(e.g. Schwaiger SPS 6814) must be connected to the multiswitch.
HINT :
When using other LNB types, be aware of their current demand!
(see chapter 3.2. of these instructions)
Switching method
Tone burst
DiSEqC commands
Remark
Example: Reception of
ASTRA/analog/digital
Eutelsat/analog/digital
Example: Reception of
ASTRA/analog/digital
Eutelsat/analog/digital
11 11