Assembly; Attaching Cable Clips; Set-Up - MAXXMEE 07925a Mode D'emploi

EN
NOTICE – Risk of Damage to
Material and Property
■
Do not expose the product to any
extreme temperatures, temperature
fluctuations or prolonged direct
sunlight.
■
Protect the product from: impacts, fire
and heat sources.
■
Do not place heavy objects on the
product or its connecting cable.
■
Pull the mains plug out of the plug
socket before a thunderstorm.
■
In the event of damage / faults, switch
the product off immediately / discon­
nect it from the mains power.
■
When you disconnect it from the
mains power, always pull on the mains
plug and never the mains cable.
■
Do not pull or carry the product by
the connecting cable.
■
Use only original accessories from the
manufacturer in order to guarantee
that there is no interference that may
prevent the product from working and
to avoid possible damage.
■
Do not connect an external dimmer!
This could damage the electronics.
■
Do not over­water the plants. Do not
leave excess water from watering
permanently in the tray.
■
Some lacquers, plastics or furniture
polishes could soften the feet of the
product. To prevent any possible resi­
dues, place a mat under the product.

ASSEMBLY

In assembling the grow light, carry out
the steps which are outlined in Illustra­
tions B1 to 5.
Check that all components fit securely
before using the product.
10
07925_Inlay_A5_de-en-fr-nl_V1.indb 10 07925_Inlay_A5_de-en-fr-nl_V1.indb 10

ATTACHING CABLE CLIPS

To ensure that the mains cable does not
get in the way, it can be secured using
the supplied cable clips (D) and adhe­
sive strips (E) to the stand (B). One cable
clip is generally enough. The others are
spares.
For the adhesive strip to stick well to
the surface, it must be dry, free of any
dust, grease, limescale or other dirt and
contamination. It should therefore be
cleaned if necessary before placing on
the adhesive strip.
1. Peel one of the protective films off the
adhesive strip.
2. Stick the adhesive strip onto a cable
clip.
3. Peel the second protective film off the
adhesive strip.
4. Stick the cable clip onto the back of
the stand and press it on.
5. Clamp the mains cable in the cable
clip.

SET-UP

Please Note!
■
Lay the connecting cable so that it is
not squashed, bent or laid over sharp
edges and does not come into con­
tact with hot surfaces.
■
Only connect the product to a plug
socket that is properly installed and
matches the technical data of the
product. The plug socket must also be
readily accessible after connection so
that the connection to the mains can
quickly be isolated.
1. After assembly, place the light on a
dry, flat surface.
2. Place the plants in the plant pots
which are also supplied (Article no.
07925b) in the tray (A).
11.05.2020 13:17:26 11.05.2020 13:17:26