Father's Cooker KY01 Manuel Du Propriétaire page 15

Before cooking on this grill for the first time, operate the grill for about 10 minutes with the lid closed and
the gas turned on "high. " This will "heat clean" the internal parts and dissipate odor from the manufacturing
processes and painted finish.
Clean your grill after each use, DO NOT use abrasive or flammable cleaners, as it will damage the parts of
this product and may start a fire.
Warning:
The location of the Burner Tube with respect to the Orifice is vital for safe operation. Check to ensure the
Orifice is inside the Burner Tube before using your gas grill. See Figure 4. If the Orifice is not inside the
burner tube, lighting the Burner may cause explosion and/or fire.
Cleaning and care:
Caution: All cleaning and maintenance should be done when grill
is cool and with the fuel supply turn off at the LP cylinder. DO NOT
clean any grill part in a self-cleaning oven. The extreme heat will
dam age the finish.
Cleaning:
Burning-off the grill before or after every use (maximum 5 minutes) will keep excessive food residues from
building up
Recommended cleaning materials:
Mild dishwashing liquid detergent
Baking soda
Paper clip
Compressed air
DO NOT use cleaners that contain acid, mineral spirits or xylene.
Outside surfaces – Use a mild dishwashing detergent and hot water solution to clean, then rinse with water.
If the inside surface of the grill lid has the appearance of peeling paint, baked on grease buildup has turned
to carbon and is flaking off. Clean thoroughly with a strong solution of detergent and hot water. Rinse with
water and allow to completely dry. NEVER USE OVEN CLEANER.
Interior of grill bottom – Remove residue using brush, scrapers and/or cleaning pad, then wash with
dishwashing detergent and hot water solution. Rinse with water and let thoroughly dry.
Cooking Grid – Use mild dishwashing detergent or baking soda and hot water solution. Non-abrasive
scouring powder can be used on stubborn stains, then rinse with water. Use Father's Cooker™ scrapping tool
on touch buildups.
Flame Tamer – Use mild dishwashing detergent or baking soda and hot water solution. Non-abrasive scour-
ing powder can be used on stubborn stains, then rinse with water and dry thoroughly.
© Les Accessoires Multifonctions Inc.
Observe Flame Height When lit:
Flame should be a Blue / Yellow color Between 1"-2"
High
Hot water
Nylon cleaning pad
compatible with stainless steel
Father's Cooker™ scraper
15 Father's Cooker™ - V2.0